Feature request #7440

loading of angled geotiffs when not displayed

Added by John Sankey almost 10 years ago. Updated over 5 years ago.

Pull Request or Patch supplied:No Resolution:
Easy fix?:No Copied to github as #:16401


I've got a large geotiff (10kx10k) that was created to WGS83; to use it in UTM 18N a small angle is needed. With the angle, it takes over a minute for 1.8.0 to load the project even when the geotiff isn't selected for display. (Yes I've pyramided it; makes no difference in project loading time, just in subsequent display.) Would it be possible on loading project to not process any layer that is not displayed, to avoid this problem?


#1 Updated by Giovanni Manghi almost 10 years ago

  • Status changed from Open to Feedback

duplicate of #3794 ?

#2 Updated by John Sankey almost 10 years ago

The feedback is the same as #3794, but I'm proposing a feature that would reduce its impact. It also might help projects with large numbers of layers (see #7425) when most aren't displayed all at the same time.

#3 Updated by Giovanni Manghi almost 6 years ago

  • Easy fix? set to No

#4 Updated by Jürgen Fischer over 5 years ago

  • Category set to Unknown

Also available in: Atom PDF