Bug report #18133

Digitizing tolerance too small in advanced interface

Added by matteo ghetta over 4 years ago. Updated over 4 years ago.

Affected QGIS version:master Regression?:No
Operating System: Easy fix?:Yes
Pull Request or Patch supplied:Yes Resolution:fixed/implemented
Crashes QGIS or corrupts data:No Copied to github as #:26026


Currently it is possible to specify only numbers of length 2, that is, the maximum tolerance is 99.99 even if the unit is meter

Associated revisions

Revision efae0fcc
Added by Arnaud Morvan over 4 years ago

Increase snapping tolerance maximum in advanced mode. Fix #18133


#1 Updated by Arnaud Morvan over 4 years ago

  • Easy fix? changed from No to Yes
  • Pull Request or Patch supplied changed from No to Yes
  • Status changed from Open to Feedback

#2 Updated by Arnaud Morvan over 4 years ago

  • % Done changed from 0 to 100
  • Status changed from Feedback to Closed

#3 Updated by Giovanni Manghi over 4 years ago

  • Resolution set to fixed/implemented

Also available in: Atom PDF