Bug report #12236

Snapping options

Added by Thomas Nogatz about 9 years ago. Updated about 8 years ago.

Affected QGIS version:2.8.0 Regression?:No
Operating System:Windows Easy fix?:No
Pull Request or Patch supplied:No Resolution:worksforme
Crashes QGIS or corrupts data:No Copied to github as #:20422



two problems with snapping options in QGIS 2.8:
1. mode Advanced is enabled by default. But Advanced mode is not really enabled after starting QGIS. You have to enable Current layer or All layers and then Advanced again to see the table of all layers (= Advanced mode). Once Advanced mode is enabled actually, the problem doesn't appear until you restart QGIS.
2. it is not possible to avoid intersections with more than one layer. Ofcourse one can activate "Avoid intersections" for more than one layer but it does only work for one layer - i suppose for the last edited layer.

Best wishes


#1 Updated by Thomas Nogatz about 9 years ago

Platform: Windows 7

#2 Updated by Jürgen Fischer about 9 years ago

  • Operating System set to Windows
  • OS version set to 7

#3 Updated by Jürgen Fischer about 9 years ago

  • Affected QGIS version changed from 2.6.0 to 2.8.0

#4 Updated by Giovanni Manghi about 9 years ago

  • Status changed from Open to Feedback

not sure I understand, the second issue is a regression/change of behavior from a previous qgis release?

#5 Updated by Giovanni Manghi about 9 years ago

  • Category set to Digitising

#6 Updated by Raymond Nijssen over 8 years ago

We checked this on the master release (2.13) today and it seems to work properly. Please check again and report within 14 days. If we don't get any more feedback we will close this issue.


#7 Updated by Giovanni Manghi about 8 years ago

  • Resolution set to worksforme
  • Status changed from Feedback to Closed

closing for lack of feedback.

Also available in: Atom PDF