Bug report #1120

k parameter always set to 0

Added by Maciej Sieczka - over 11 years ago. Updated about 10 years ago.

Status:Closed
Priority:Low
Assignee:nobody -
Category:Projection Support
Affected QGIS version: Regression?:No
Operating System:All Easy fix?:No
Pull Request or Patch supplied: Resolution:fixed
Crashes QGIS or corrupts data: Copied to github as #:11180

Description

1. load any shapefile

2. file > properties > change SRS

3. choose any SRS with k!=0 (eg. EPSG 2172, 2180)

4. apply, ok

5. enter properties again - see the k parameter is set to 0!

Same happens if the SRS with a k!=0 is assigned automatically at the layer's load time.

Associated revisions

Revision 3e3d1608
Added by Jürgen Fischer over 11 years ago

call OSRImportFromProj4() in locale "C" (fixes #1120)

git-svn-id: http://svn.osgeo.org/qgis/trunk/[email protected] c8812cc2-4d05-0410-92ff-de0c093fc19c

Revision 2b3bb91e
Added by Jürgen Fischer over 11 years ago

call OSRImportFromProj4() in locale "C" (fixes #1120)

git-svn-id: http://svn.osgeo.org/qgis/[email protected] c8812cc2-4d05-0410-92ff-de0c093fc19c

History

#1 Updated by Maciej Sieczka - over 11 years ago

Notice: the issue takes place only in pl_PL.UTF-8. QGIS started from a terminal after "export LC_ALL=C" does not have this problem.

Probably the bug is down to , vs . as a decimal separator - pl_PL.UTF-8 uses comma.

#2 Updated by Jürgen Fischer over 11 years ago

  • Resolution set to fixed
  • Status changed from Open to Closed

should be fixed in 2b3bb91e (SVN r8593)

#3 Updated by Anonymous about 10 years ago

Milestone Version 0.9.2 deleted

Also available in: Atom PDF